Observing Boot Messages - Lucent Technologies PortMaster OR-HS Hardware Installation Manual

Observing Boot Messages

If you are having difficulty starting the Office Router and are unable to isolate the
problem by observing LED behavior, start the Office Router in console mode and
check the boot messages.
Follow these instructions to check boot messages:
1. Attach a console (see "Connect a Console" on page 2-4).
2. Turn on power (see "Turn On Power" on page 2-12).
3. Observe the boot messages displayed on the console screen.
Note – Boot messages vary slightly, depending on the version of the
programmable ROM (PROM) and ComOS.
The following example of boot messages is from an OR-M:
Livingston Enterprises, Inc. Boot Prom Rev K
Testing Low Memory ....
Testing System Clock ....
Testing System Memory .... A000
Checking Boot Rom ....
Starting FLASH Boot .....
Booting From Flash Type Am29F040
Loading Image at 0fff0000
320112 flash copy complete
Verifying Load Module Checksum ...
Starting Load Module ...
Testing High Memory ... . 1024K
PCMCIA slot .... PCMCIA card type
Found 2 ports....
Running ComOS...
PortMaster Console login:
Troubleshooting
Observing Boot Messages
A-5