Observing The Console Display (Or-M - Lucent Technologies PortMaster OR-HS Hardware Installation Manual

Observing the Console Display (OR-M)

Table A-1
LED Indication
An undefined difficulty
occurred at startup, but the
cause cannot be determined
from LED behavior.
Observing the Console Display (OR-M)
Follow these instructions if port S1 does not appear on the console display during
configuration of the Office Router:
1. Turn the power switch off.
2. Reinsert the PCMCIA modem card.
Consult the manufacturer's documentation to ensure that the modem card is
inserted with the correct side up. (See "Connect a PCMCIA Modem (OR-M)" on
page 2-9.)
3. Turn on power (see "Turn On Power" on page 2-12).
A-4
Hardware Problems and Solutions (Continued)
Likely Cause
See the solution column.
Solution
Try starting in console mode,
and observe the boot
messages. See "Observing Boot
Messages" on page A-5. If the
boot messages do not suggest a
solution, record the
information and contact
Lucent Remote Access
Technical Support.
PortMaster Office Router Hardware Installation Guide