Connect An Analog Device (Or-St-Ap And Or-U-Ap); Required Equipment For A Telephone Or Fax; Required Equipment For An External Modem; Procedure - Lucent Technologies PortMaster OR-HS Hardware Installation Manual

Connect an Analog Device (OR-ST-AP and OR-U-AP)

The PCMCIA modem will click into the PCMCIA slot when it is fully seated.
2. Connect the modem cable to the PCMCIA modem and to an analog wall
jack.
8. Connect an Analog Device (OR-ST-AP and OR-U-AP)
Follow these instructions to connect an analog telephone, fax, or external modem to
the analog PHONE port on the OR-ST-AP or OR-U-AP.

Required Equipment for a Telephone or Fax

Four-pin RJ-11 cable. This cable is available from most telephone equipment
suppliers.

Required Equipment for an External Modem

RJ-45-to-DB-25-Male modem cable. This cable can be ordered from Lucent
Technologies by specifying product code CBL-MDB45. (See "Modem Cable" on
page D-3 for pinout information.)
Four-pin RJ-11 cable. This cable is usually shipped with an external modem.
Additional cables are available from most telephone equipment suppliers.

Procedure

Caution – Do not connect an analog telephone line directly to any port of the Office
!
Router.
2-10
Ethernet S1 - PC-Card
1186-0015
S1 - PC-Card
PortMaster Office Router Hardware Installation Guide
S0