Yamaha T135SE Service Manual page 99

CHECKING AND CHARGING THE BATTERY
2
9 warpage or buckling of the battery plates or
insulators is evident.
9. Check:
9 battery breather hose and battery vent
Obstruction → Clean.
Damage → Replace.
10. Install:
9 battery
11. Connect:
9 battery breather hose 1
cC
99
When checking the battery, make sure the
battery breather hose is properly installed
1
and routed correctly. If the battery breather
hose is positioned so as to allow elec-
trolyte or hydrogen gas from the battery to
contact the frame, the vehicle and its fin-
ish may be damaged.
99
Make sure the battery breather hose is
properly routed away from the drive chain
and from below the swingarm.
12. Check:
9 battery terminals
Dirt → Clean with a wire brush.
Loose connection → Connect properly.
13. Connect:
1
9 battery leads
(to the battery terminals)
cC
First, connect the positive battery lead
and then the negative battery lead 2 .
14. Lubricate:
9 battery terminals
15. Install:
9 battery band
3-45
http://www.motorcycle.in.th
CHK
ADJ
Recommended lubricant
Dielectric grease
1 ,