Yamaha T135SE Service Manual page 87

Manual clutch and automatic sniper / jupiter mx / spark 135 / exciter / 135lc
Hide thumbs Also See for T135SE:
Table of Contents

Advertisement

ADJUSTING THE DRIVE CHAIN SLACK
a
b
a
2
1
1. Stand the vehicle on a level surface.
w
Securely support the vehicle so that there is
no danger of it falling over.
NOTE:
Place the vehicle on a suitable stand so that the
rear wheel is elevated.
2. Spin the rear wheel several times and find
the tightest position of the drive chain.
3. Check:
9 drive chain slack a
Out of specification → Adjust.
Drive chain slack
25–35 mm (0.93–1.38 in)
4. Adjust:
9 drive chain slack
a. Loosen the wheel axle nut.
b. Loosen both locknuts 1 .
c. Turn both adjusting nuts 2 in direction a
or b until the specified drive chain slack is
obtained.
aa
Direction
bb
Direction
NOTE:
To maintain the proper wheel alignment, adjust
both sides evenly.
d. Tighten both locknuts to specification.
Locknut
7 Nm (0.7 m·kg, 5.0 ft·lb)
e. Tighten the wheel axle nut to specification.
Wheel axle nut
60 Nm (6.0 m·kg, 43 ft·lb)
3-33
http://www.motorcycle.in.th
CHK
ADJ
Drive chain is tightened.
Drive chain is loosened.

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

T135sSniperExciterJupiter mxSpark 135135lc ... Show all

Table of Contents