Checking The Brake - Yamaha T135SE Service Manual

REAR WHEELAND BRAKE
a
http://www.motorcycle.in.th
EAS00539

CHECKING THE BRAKE

The following procedure applies to all of the
brake shoes.
1. Check:
9 brake shoe lining
Glazed areas → Repair.
Sand the glazed areas with course sandpa-
per.
NOTE:
After sanding the glazed areas, clean the brake
shoe with a cloth.
2. Measure:
9 brake shoe lining thickness a
Out of specification → Replace.
Brake shoe lining thickness limit
(minimum)
2.0 mm (0.08 in)
w
Do not allow oil or grease to contact the
brake shoes.
NOTE:
Replace the brake shoes as a set, if either is
worn to the wear limit.
3. Measure:
9 brake drum inside diameter a
Out of specification → Replace the wheel.
Brake drum inside diameter limit
(maximum)
131 mm (5.16 in)
4. Check:
9 brake drum inner surface
Oil deposits → Clean.
Remove the oil with a rag soaked in lacquer
thinner or solvent.
Scratches → Repair.
Lightly and evenly polish the scratches with
an emery cloth.
5. Check:
9 brake camshaft
Damage/wear → Replace.
7-13
CHAS