Yamaha T135SE Service Manual page 248

1
1
2
FRONT BRAKE
2. Remove:
9 clips
9 brake pad retaining pin
9 brake pads 1
9 brake pad spring
3. Measure:
9 brake pad wear limit a
a
Out of specification
pads as a set.
4. Install:
9 brake pad spring
9 brake pads
NOTE:
Always install new brake pads and a new brake
pad spring as a set.
a. Connect a clear plastic hose 1 tightly to the
bleed screw 2 . Put the other end of the
hose into an open container.
b. Loosen the bleed screw and push the brake
caliper pistons into the brake caliper with
your finger.
c. Tighten the bleed screw.
d. Install new brake pads and a new brake pad
spring.
NOTE:
Make sure the brake pad spring is installed cor-
rectly as shown.
7-18
http://www.motorcycle.in.th
CHAS
→ Replace the brake
Brake pad wear limit
0.8 mm (0.03 in)
Bleed screw
6 Nm (0.6 m·kg, 4.3 ft·lb)