Checking The Engine Oillevel - Yamaha T135SE Service Manual

Manual clutch and automatic sniper / jupiter mx / spark 135 / exciter / 135lc
Hide thumbs Also See for T135SE:
Table of Contents

Advertisement

MEASURING THE COMPRESSION PRESSURE/

CHECKING THE ENGINE OILLEVEL

1
b
a
8. Install:
9 spark plug
9. Connect:
9 spark plug cap
10. Install:
9 side cowling (right)
Refer to "INSTALLING THE SIDE COWL-
INGS".
EAS00070
CHECKING THE ENGINE OILLEVEL
1. Stand the vehicle on a level surface.
NOTE:
Make sure the vehicle is upright.
2. Start the engine, warm it up for several min-
utes, and then turn it off.
3. Remove:
9 oil level plug 1
4. Check:
9 engine oil level
The engine oil level should be between the
minimum level mark a and maximum level
mark b .
Below the minimum level mark
recommended engine oil to the proper level.
Recommended oil
SAE 20W40 type SF or SAE 20W50
motor oil
cC
Do not allow foreign materials to enter the
crankcase.
NOTE:
9 Insert the oil level plug back into the oil filler
hole (without screwing it in), and then remove
it again to check the oil level.
9 Before checking the engine oil level, wait a few
minutes until the oil has settled.
5. Start the engine, warm it up for several min-
utes, and then turn it off.
6. Check the engine oil level again.
3-17
http://www.motorcycle.in.th
CHK
ADJ
13 Nm (1.3 m•kg, 9.5 ft•lb)
→ Add the

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

T135sSniperExciterJupiter mxSpark 135135lc ... Show all

Table of Contents