Set Spantree; Set Spantree Priority; Set Autopartition - Avaya P334T-ML User Manual

Chapter 6 CLI – Layer 2

set spantree

Use the set spantree command to enable/disable the spanning-tree protocol
for the stack.
Note: When you disable STP, blocking ports are disabled in order to prevent loops
in the network. As a result, you should wait 30 seconds before disabling STP if you
reset the switch, enabled STP, or inserted a new station.
The syntax for this command is:
set spantree {enable|disable}
Output Example:
P330-N# set spantree enable
bridge spanning tree enabled.

set spantree priority

Use the set spantree priority command to set the bridge priority for STP.
The syntax for this command is:
set spantree priority <value>
value
Example:
To set the priority to 45000:
P330-N# set spantree priority 45000
Priority enabled

set autopartition

Use the set autopartition command to enable or disable auto-partitioning on
specific P330 switches in the stack. This command can not be executed on the P330-
ML switches. This command is used to set the autopartition status for the other
P330 switches in the stack.
The syntax for this command is:
set autopartition <enable|disable>[module]
126
Number representing the priority of the bridge with a priority
level from 0 to 65535, with 0 indicating high priority and 65535
indicating low priority.
Avaya P334T-ML User's Guide