Installing The Power Cord Retainer (Optional) - Cisco Catalyst 3560-C Hardware Installation Manual

Chapter 2 Switch Installation

Installing the Power Cord Retainer (Optional)

This section applies to switches with an AC power connector.
Note
The power cord retainer part number (PWR-CLP=) is optional. You can order it when you order your
switch, or you can order it later from your Cisco representative.
Choose the sleeve size of the power cord retainer based on the thickness of the cord. The smaller sleeve
Step 1
can be snapped off and used for thin cords. See
Slide the retainer around the AC power cord, and pass it around the loop on the switch. See
Step 2
Figure 2-23
1
1
2
OL-23803-02
Inserting the Retainer through the Lanced Loop
R E S E T
2 3
AC power cord
Power cord retainer

Installing the Power Cord Retainer (Optional)

Figure 2-26.
4
3 Sleeve for thinner power cords
4
Loop
Catalyst 3560-C and 2960-C Switch Hardware Installation Guide
Figure 2-23.
2-25