Removing A Flexstack Cable; Installing The Power Cord Retainer (Optional) - Cisco Catalyst 2960-X Hardware Installation Manual

Switch Installation
Step 3 Replace the dust covers when you remove the FlexStack cables from the connectors.
Caution

Removing a FlexStack Cable

Procedure
Step 1 To remove a FlexStack cable, grasp the tab on the cable connector and gently pull straight out.
Step 2 When you remove the FlexStack cables from the connectors, replace the dust covers to protect them from
dust.
Caution

Installing the Power Cord Retainer (Optional)

This section applies only to the Catalyst 2960-X switches.
Note
The power cord retainer is optional (part number [PWR-CLP=]). You can order it when you order your switch,
or you can order it later from your Cisco representative.
OL-28309-02
Removing and installing the FlexStack cable can shorten its useful life. Do not remove and insert
the cable more often than is absolutely necessary.
Removing and installing the FlexStack cable can shorten its useful life. Do not remove and insert
the cable more often than is absolutely necessary.
Catalyst 2960-X and 2960-XR Switch Hardware Installation Guide
Removing a FlexStack Cable
25