Installing The Cable Guard (Optional) - Cisco Catalyst 3560-C Hardware Installation Manual

Installing the Cable Guard (Optional)

Installing the Cable Guard (Optional)

The cable guard prevents tampering with the cables after the cables are installed. The cable guard
(CMP-CBLE-GRD=) is not included with the switch, but you can order it from your Cisco
representative.
You can use the cable guard when the switch is mounted on a desk, under a desk, or on a wall.
Note
The cable guard is shipped with these items:
•
•
•
(Optional) Attach the supplied washers before you install the cable guard. See
Step 1
Note
Figure 2-28
M OD E
1
Catalyst 3560-C and 2960-C Switch Hardware Installation Guide
2-28
Two 0.5 in. (12.7 mm) number-8 Phillips wood screws
Two number-10 Phillips pan-head screws
Two washers
This is only required if you are not installing the wall-mount brackets.
Using the Washer
SYS T
STA T
DP LX
1
2
SPD
3
Po E 4
5
PD 6
CO NS OL
E
PO W ER
OV ER
ET HE RN
ET
Washer
Se r i es
PD
7
8
1
2
Chapter 2 Switch Installation
Figure 2-28.
1
OL-23803-02