Cisco Catalyst 3560-C Hardware Installation Manual page 91

Appendix C Configuring the Switch with the CLI Setup Program
Entering the Initial Configuration Information
!
interface FastEthernet1/0/2
interface FastEthernet1/0/3
!
...<output abbreviated>
end
These choices appear:
Step 10
[0] Go to the IOS command prompt without saving this config.
[1] Return back to the setup without saving this config.
[2] Save this configuration to nvram and exit.
If you want to save the configuration and use it the next time the switch reboots, select option 2 to
save it in NVRAM.
Enter your selection [2]:2
Make your selection, and press Return.
After you complete the setup program, the switch can run the default configuration that you created. To
change this configuration or to perform other management tasks, enter commands at the .
Switch> prompt
Catalyst 3560-C and 2960-C Switch Hardware Installation Guide
C-9
OL-23803-02