Cisco Catalyst 3560-C Hardware Installation Manual page 35

Chapter 2 Switch Installation
Figure 2-3
1 Desk or shelf
2
Screw template
Use a 0.144-inch (3.7 mm) or a #27 drill bit to drill a 1/2-inch (12.7 mm) hole in the three screw
Step 4
template slots.
Insert three screws in the slots on the screw template, and tighten until they touch the top of the screw
Step 5
template.
Remove the screw template from underneath the desk or shelf.
Step 6
Place the switch upside down onto the mounting screws, and slide it forward until it locks in place. See
Step 7
Figure
To prevent airflow restriction, allow clearance around the ventilation openings to be at least:
Warning
3 in. (7.6 cm) Statement 1076
OL-23803-02
Installing the Mounting Screws Under a Desk or Shelf
1
2
3
3 Screws
4
Adhesive
2-4.
4
3
Catalyst 3560-C and 2960-C Switch Hardware Installation Guide
Mounting the Switch
2-9