Entering The Initial Configuration Information; Ip Settings; Completing The Setup Program - Cisco Catalyst 3560-C Hardware Installation Manual

Appendix C Configuring the Switch with the CLI Setup Program
When the Remove the Program window appears, click Remove.
Step 4
If a User Account Control warning appears, click Allow - I trust this program to proceed.
Note
When the InstallShield Wizard Completed window appears, click Finish.
Step 5

Entering the Initial Configuration Information

To set up the switch, you need to complete the setup program, which runs automatically after the switch
powers on. You must assign an IP address and other configuration information necessary for the switch
to communicate with the local routers and the Internet.

IP Settings

You need this information:
•
•
•
•
•
•

Completing the Setup Program

Follow these steps to complete the setup program and to create an initial configuration for the switch:
Enter Yes at these two prompts.
Step 1
Would you like to enter the initial configuration dialog? [yes/no]: yes
At any point you may enter a question mark '?' for help.
Use ctrl-c to abort configuration dialog at any prompt.
Default settings are in square brackets '[]'.
Basic management setup configures only enough connectivity
for management of the system, extended setup will ask you
to configure each interface on the system.
Would you like to enter basic management setup? [yes/no]: yes
Enter a host name for the switch, and press Return.
Step 2
On a command switch, the host name is limited to 28 characters and on a member switch to 31
characters. Do not use -n, where n is a number, as the last character in a host name for any switch.
Enter host name [Switch]: host_name
OL-23803-02
Switch IP address
Subnet mask (IP netmask)
Default gateway (router)
Enable secret password
Enable password
Telnet password
Entering the Initial Configuration Information
Catalyst 3560-C and 2960-C Switch Hardware Installation Guide
C-7