After Switch Installation; Installing The Power Cord Retainer (Optional) - Cisco Catalyst 1000 Series Hardware Installation Manual

Switch Installation
Step 2
Attach the four rubber feet to the four circular etches on the bottom of the chassis.
Step 3 Place the switch on the table or shelf near an AC power source.
Step 4
When you complete the switch installation, see After Switch Installation for information on switch configuration.

After Switch Installation

• Configure the switch using the Configuration Setup wizard to enter the initial switch configuration.
• Install the power cord retainer (optional).
• Connect to the front-panel ports.

Installing the Power Cord Retainer (Optional)

The power cord retainer is optional (part number [PWR-CLP=]). You can order it when you order your switch.
Procedure
Step 1 Choose the sleeve size of the power cord retainer based on the thickness of the cord. The smaller sleeve can
be snapped off and used for thin cords.
Step 2 Slide the retainer around the AC power cord, and pass it around the loop on the switch.
Figure 14: Inserting the Retainer Through the Lanced Loop
1
2
Step 3
Slide the retainer through the first latch.
AC power cord
Power cord retainer
Cisco Catalyst 1000 Series 24-Port and 48-Port Switch Hardware Installation Guide
3 Sleeve for thinner power
cords
4 Loop
After Switch Installation
25