Cisco Catalyst 3560-C Hardware Installation Manual page 33

Chapter 2 Switch Installation
Figure 2-1
1 Screw template 3
2 Screws
Peel the adhesive strip off the bottom of the screw template, and attach it to the top of the desk or shelf.
Step 3
Use a 0.144-inch (3.7 mm) or a #27 drill bit to drill a 1/2-inch (12.7 mm) hole in the three screw
Step 4
template slots.
Insert three screws in the slots on the screw template, and tighten them until they touch the top of the
Step 5
screw template.
Remove the screw template from the desk or shelf.
Step 6
Place the switch onto the mounting screws, and slide it forward until it locks in place. See
Step 7
Warning To prevent airflow restriction, allow clearance around the ventilation openings to be at least:
3 in. (7.6 cm) Statement 1076
OL-23803-02
Installing the Mounting Screws on Top of a Desk or a Shelf
2
3
1
Desk or shelf
Catalyst 3560-C and 2960-C Switch Hardware Installation Guide
Mounting the Switch
Figure 2-2.
2-7