Poe Led; Pd Led; Dual-Purpose Port Leds - Cisco Catalyst 3560-C Hardware Installation Manual

Front Panel

PoE LED

Even if the PoE mode is not selected, the LED shows PoE problems when they are detected
The PoE LED is only on the switches that support PoE.
Table 1-8
Color
Off
Green
Blinking amber

PD LED

Applies only to the Catalyst 2960CPD-8PT-L and 3560PD-8PT-S switches.
Table 1-9
Color
Off
Blinking amber
Amber
Amber/green
Green

Dual-Purpose Port LEDs

The dual-purpose port LEDs identify the connection as either a copper-based connector or an SFP
module. The ports can autonegotiate, or you can manually configure each dual-purpose port as either
10/100/1000 with copper connectors or as an SFP-module port, but not as both types at the same time.
See
Catalyst 3560-C and 2960-C Switch Hardware Installation Guide
1-14
PoE LED
PD LED
Table 1-7 for LED descriptions.
Meaning
PoE is not enabled.
PoE is enabled. Ports are functioning correctly.
PoE mode is not selected.
•
At least one of the 10/100 or 10/100/100 PoE ports has been
•
denied power.
or
At least one of the ports has a PoE fault.
•
Meaning
Switch is not powered up.
Switch is receiving power from a PoE device, but it is insufficient
to power up the switch.
Switch is powered by only the auxiliary power adapter.
Switch is powered by the auxiliary power but is also receiving
power from a PoE device.
Switch is powered by a PoE switch through a PoE uplink port.
Chapter 1 Product Overview
(Table 1-8).
(Table 1-9).
OL-23803-02