Poe Led; Port Leds And Modes - Cisco Catalyst C9200L-48PXG-4X-E Hardware Installation Manual

PoE LED

3

PoE LED

The PoE LED indicates the status of the PoE mode: either PoE or PoE+.
Table 25: PoE LED
Color
Off
Green
Blinking amber

Port LEDs and Modes

Each Ethernet port, 1-Gigabit Ethernet module slot, and 10-Gigabit Ethernet module slot has a port LED.
These port LEDs, as a group or individually, display information about the switch and about the individual
ports. The port mode determines the type of information shown by the port LEDs.
To select or change a mode, press the Mode button until the desired mode is highlighted. When you change
port modes, the meanings of the port LED colors also change.
When you press the Mode button on any switch in the switch stack, all the stack switches change to show the
same selected mode. For example, if you press the Mode button on the active switch to show the SPEED
LED, all the other switches in the stack also show the SPEED LED.
Table 26: Port Mode LEDs
Mode LED
STAT
SPEED
DUPLX
ACTV
STACK
PoE
Cisco Catalyst 9200 Series Switches Hardware Installation Guide
82
Stack member 3
Description
PoE mode is not selected. None of the 10/100/1000 ports have been denied power
or are in a fault condition.
PoE mode is selected, and the port LEDs show the PoE mode status.
PoE mode is not selected. At least one of the 10/100/1000 ports has been denied
power, or at least one of the 10/100/1000 ports has a PoE mode fault.
Port Mode
Port status
Port speed
Port duplex mode
Active
Stack member status
StackWise port status
3
The PoE+ port status.
6
Description
The port status. This is the default mode.
The port operating speed: 10, 100, or 1000 Mb/s.
The port duplex mode: full duplex or half duplex.
The active switch status.
Stack member status.
The StackWise port status. See
The PoE+ port status.
Switch LEDs
LED blinks green to show
that this is switch 3 in the
stack.
STACK LED, on page 81.