Poe Led; Xps Led; S-Pwr Led - Cisco Catalyst 9300 Series Hardware Installation Manual

Product Overview

PoE LED

The PoE LED indicates the status of the PoE mode: either PoE, PoE+, or Cisco UPOE.
Table 9: PoE LED
Color
Off
Green
Blinking amber

XPS LED

Note
Table 10: XPS LED
Color
Off
Green
Blinking green
Amber
Blinking amber
For information about the XPS 2200, see the Cisco eXpandable Power System 2200 Hardware Installation
Guide on Cisco.com:
http://www.cisco.com/go/xps2200_hw

S-PWR LED

Table 11: S-PWR LED
Color
Off
Description
PoE mode is not selected. None of the 10/100/1000 ports have been denied power
or are in a fault condition.
PoE mode is selected, and the port LEDs show the PoE mode status.
PoE mode is not selected. At least one of the 10/100/1000 ports has been denied
power, or at least one of the 10/100/1000 ports has a PoE mode fault.
This LED is not supported on Cisco Catalyst 9300L Series switches.
Description
XPS cable is not installed.
Switch is in StackPower mode.
XPS is connected and ready to provide back-up power.
XPS is connected but is unavailable because it is providing power to another device
(redundancy has been allocated to a neighboring device).
The XPS is in standby mode or in a fault condition. See the XPS 2200
documentation for information about the standby mode and fault conditions.
The power supply in a switch has failed, and the XPS is providing power to that
switch (redundancy has been allocated to this device).
Description
StackPower cable is not connected, or the switch is in standalone mode.
Cisco Catalyst 9300 Series Switches Hardware Installation Guide
PoE LED
17