Care, Maintenance & Troubleshooting Guide - LifeGear 97240 Owner's Manual

CARE, MAINTENANCE & TROUBLESHOOTING GUIDE
WARNING: To prevent electrical shock, please turn off and unplugg(ed) the treadmill
before cleaning or performing routine maintenance.
CLEANING
The treadmill can be cleaned with a soft cloth and mild detergent. Do not use abrasives or
solvents. Be careful not get excessive moisture on the display panel as this might cause
an electrical hazard or electronics to fail.
Please keep the treadmill, especially, the console, out of direct sunlight to prevent screen
damage.
STORAGE
Store the treadmill in a clean and dry environment. Ensure the master power switch is off
and is in the off position and the power plug is un-plugged from the electrical wall outlet.
TROUBLESHOOTING GUIDE
Problem
Treadmill will not
start.
Belt slips.
Belt hesitates
When stepped
on.
Belt is off
centered.
Potential Causes
1. Not plugged in.
2. Safety tether key not
connected.
3. House circuit breaker
tripped.
4. Treadmill circuit breaker
tripped.
Belt not tight enough.
1. Not enough lubrication
applied onto the running
deck.
2. Belt is too tight.
Running belt tension not
even across the rear roller.
1. Put the power plug into the
electrical wall outlet.
2. Install the safety tether key.
3. Reset or have an electrician
replace the breaker in home.
4. Wait five minutes and then
press the switch back in.
Adjust belt tension.
1. Apply silicone lubricant.
2. Adjust belt tension.
Center the belt.
16
Corrections