Care, Maintenance & Troubleshooting Guide - LifeGear 97018 Owner's Manual

CARE, MAINTENANCE & TROUBLESHOOTING GUIDE
WARNING: To prevent electrical shock, please turn off and unplug the treadmill before
cleaning or performing routine maintenance.
WARNING: Always check the wear and tear components like foot lock latch tube and
running belt to prevent injury.
CLEANING
After each exercise, ensure that the unit is wiped down and any sweat is removed
from the unit.
The treadmill can be cleaned with a soft cloth and mild detergent. Do not use abrasives
or solvents. Be careful not to get excessive moisture on the display panel as this might
damage the unit and create an electrical hazard.
Please keep the treadmill, especially the computer console, out of direct sunlight to
prevent damage to the screen.
STORAGE
Store the treadmill in a clean and dry indoor environment. Never leave or use the unit
outdoors. Ensure the master power switch is off and the power cord is un-plugged from
wall outlet.
TROUBLESHOOTING GUIDE
Problem
Treadmill will not
start.
Belt slips.
Belt hesitates when
stepped on.
Belt is not centred.
Potential Causes
1. Treadmill not plugged in.
2. Safety Tether Key is not
correctly installed.
3. Circuit breaker in the
house has been tripped.
4. Treadmill circuit breaker
has been tripped.
Belt not tight enough.
1. Not enough lubrication
applied onto the running
deck.
2. Belt is too tight.
Running belt tension not even
across the rear roller.
1. Plug the power cord into a wall
outlet.
2. Reinstall the Safety Tether Key.
3. Reset the circuit breaker, or call
an electrician to replace the
circuit breaker.
4. Wait 5 minutes and then try to
restart the treadmill.
Adjust belt tension.
1. Apply lubricant.
2. Adjust belt tension.
Centre the belt.
23
Corrections