Area Authentication - Zte ZXR10 Command Manual

ZXR10 Command Manual (IPv4 Routing Volume I)
Purpose
Command Modes
Syntax
Syntax
Description
Defaults
Instructions
Example
30 Confidential and Proprietary Information of ZTE CORPORATION
mpls traffic-eng area..........................................................61
mpls traffic-eng router-id....................................................62
neighbor ..........................................................................62
network ...........................................................................63
no area ............................................................................65
notify default route ............................................................65
nsf ..................................................................................66
passive-interface ...............................................................67
redistribute.......................................................................67
router ospf .......................................................................69
router-id ..........................................................................70
show ip ospf .....................................................................70
show ip ospf border-lfas .....................................................72
show ip ospf border-routers ................................................73
show ip ospf database........................................................74
show ip ospf interface ........................................................84
show ip ospf mpls traffic-eng link.........................................86
show ip ospf neighbor ........................................................87
show ip ospf nsf ................................................................89
show ip ospf request-list.....................................................90
show ip ospf retransmission-list...........................................91
show ip ospf virtual-links ....................................................91
summary-address..............................................................92
timers lsa-group-pacing .....................................................93
timers spf.........................................................................93

area authentication

Use this command to enable the authentication in the OSPF area.
Disable the authentication with the no command.
Router configuration
area <area-id> authentication [message-digest]
no area <area-id> authentication [message-digest]
<area-id>
message-digest
There is no authentication by default.
� This command is supported after the 4.6.02 platform version.
�
If there is no parameter, the type 1 (simple password ) au-
thentication will be used. If there is a parameter , the type 2
(message digest) authentication will be used.
� If the area does not exist, it will be created automatically.
This example uses type 2 authentication on area 1.
ZXR10(config)#router ospf 1
ZXR10(config-router)#area 1 authentication message-digest
Area identifier, a decimal number
(0~4294967295) or a dotted decimal IP
address
Use the type 2 (message digest)
authentication in the area