Area Stub - Zte ZXR10 Command Manual

ZXR10 Command Manual (IPv4 Routing Volume I)
Example
Related
Commands
Purpose
Command Modes
Syntax
Syntax
Description
Defaults
Instructions
36 Confidential and Proprietary Information of ZTE CORPORATION
command
bfd
frr
resync_timeout
passive-interface
ii. The changes only take effect on the sham-link interfaces
that are up.
iii. If the neighbor of sham-link is already up, the changes of
the interface will take no effect on the sham-link neighbor
because the DC link will no more send or receive the hello
packets. The changes will take effect only when the next
link is established.
This example configures a sham-link of area 1 on the router. The
local loopback interface address sham-link uses is 10.22.1.1. The
remote destination address is 10.22.1.2, and the specified cost is
100.
ZXR10(config)#router ospf 1
ZXR10(config-router)#area 1 sham-link 10.22.1.1 10.22.1.2 cost 100
redistribute bgp-int

area stub

Use this command to define an area as a stub area. Cancel the
configuration with the no form of this command.
Router configuration
area <area-id> stub [no-summary][default-cost <cost>]
no area <area-id> stub [no-summary][default-cost]
<area-id>
no-summary
default-cost<cost>
No stub area is defined.
For the stub area, the ABR can send the summary route informa-
tion to the stub area by default, and the cost for advertising the
default rout to the stub area is 1.
� This command is supported after the platform version 4.6.02.
taking effect or not
No
No
No
No
Area identifier, a decimal value
(0~4294967295) or a dotted decimal
IP address
Forbid ABR from sending the summary routing
information to this stub area
Cost for advertising default routes to this stub
area, scope: 0~65535