I-Spf; Lsp-Refresh-Time - Zte ZXR10 Command Manual

ZXR10 Command Manual (IPv4 Routing Volume I)
Syntax
Syntax
Description
Defaults
Example
Purpose
Command Modes
Syntax
Example
Purpose
Command Modes
Syntax
Syntax
Description
112 Confidential and Proprietary Information of ZTE CORPORATION
is-type {level-1 | level-1-2 | level-2-only}
no is-type
level-1
level-1-2
level-2-only
The default level value is level-1-2.
This example configures the allowed level of IS-IS.
ZXR10(config)#router isis
ZXR10(config-router)#is-type level-1
ZXR10(config-router)#is-type level-2
ZXR10(config-router)#is-type level-1-2

i-spf

Use this command to configure the incremental SPF calculation
IS-IS instances support. Delete the configuration with the no form
of this command.
Router configuration

i-spf

no i-spf
This example configures the incremental SPF calculation IS-IS in-
stances support and then cancels it with the no form of the com-
mand.
ZXR10(config)#router isis
ZXR10(config-router)#i-spf
ZXR10(config-router)#no i-spf

lsp-refresh-time

Use this command to set LSP refresh time. Restore default with
no form of this command.
Router configuration
lsp-refresh-time <time>
no lsp-refresh-time
<time>
The router is in area Level-1
The router is in area Level-1–2
The router is in area Level-2 only
Refresh time, in seconds range
:1~65535default: 900 seconds