Area Stub-Host - Zte ZXR10 Command Manual

Example
Purpose
Command Modes
Syntax
Syntax
Description
Defaults
Instructions
� The area will be created automatically if it does not exist. It can
specify whether to forbid the ABR from sending the summary
network route information to the stub area. At the same time,
the cost for advertising the default rout to the stub area can
be specified.
� The no area <area-id> stub no-summary command is used
to allow the ABR to send the summary route information to the
stub area.
� The no area <area-id> stub default-cost is used to reset
the cost of advertising the default route to the stub area as the
default 1.
�
The no area <area-id> stub command is used to change the
specified area from stub to non-stub .
� If the area does not exist, it will be created automatically.
� Area 0, nssa area and the area with virtual links cannot be
configured as the stub area.
This example configures area 1 as a stub area, forbids sending the
summary state advertisement to this area, sets the default cost
as 10 and then restores it to the default value.
ZXR10(config)#router ospf 1
ZXR10(config-router)#area 1 stub no-summary default-cost 10
... ...
ZXR10(config)#router ospf 1
ZXR10(config-router)#no area 1 stub no-summary
ZXR10(config-router)#no area 1 stub default-cost

area stub-host

Use this command to add the host route advertised by the local
router in some area. Cancel the setting with the no form of this
command.
Router configuration
area <area-id> stub-host <ip-address> cost <cost>
no area <area-id> stub-host <ip-address>[cost <cost>]
<area-id>
<ip-address>
cost <cost>
There is no host route advertised by local router in the area.
� This command is supported after the platform version 4.6.02.
� The no area <area-id> stub-host <ip-address> command
deletes the host route advertised by local router in an area.
Confidential and Proprietary Information of ZTE CORPORATION
Area identifier, a decimal value
(0~4294967295) or a dotted decimal
IP address.
Host IP address advertised by the stub host,
in the form of dotted decimal
Cost for advertising the host route, scope:
1~65535
Chapter 3 OSPF Protocol
37