Network - Zte ZXR10 Command Manual

Syntax
Description
Defaults
Instructions
Example
Related
Commands
Purpose
Command Modes
Syntax
Syntax
Description
Defaults
Instructions
<ip-address>
No neighbor is configured.
� This command allows exchanging the RIP route information in
the point-to-point (non-broadcast) mode. Once a neighbor is
specified, the interface that is in the same network as local
interface will not exchange the RIP route information in the
broadcast (multicast) mode.
�
When the use of the ip rip interface passive command on
some interface make it only receive but not send route infor-
mation, then after the use of the neighbor command can allow
the router to exchange route information with the neighbor on
this interface.
� Use multiple neighbor commands to specify additional adja-
cency routers or the peer routers.
� Recently 255 neighbors, at most, can be found or configured
at the same time.
This example configures the address 10.10.10.2 as the neighbor
router.
ZXR10(config)#router rip
ZXR10(config-router)#neighbor 10.10.10.2
ip rip neighbor-restrict
ip rip interface passive

network

Use this command to specify the network table for RIP routing.
Clear the setting with the no form of this command.
Router configuration and address family configuration
network <ip-address><net-mask>
no network <ip-address><net-mask>
<ip-address>
<net-mask>
This command is disabled by default.
�
Multiple network commands can be specified. The RIP route
update information can be sent or received only through these
network interfaces.
Confidential and Proprietary Information of ZTE CORPORATION
IP address of the peer router exchanging
route information with local router, in the
form of dotted decimal
directly connected IP address of the network ,
in the form of dotted decimal
Inverse mask of the network number, in the
form of dotted decimal
Chapter 2 RIP Protocol
19