Ip Rip Authentication Key-Chain - Zte ZXR10 Command Manual

ZXR10 Command Manual (IPv4 Routing Volume I)
Syntax
Description
Defaults
Instructions
Example
Related
Commands
Purpose
Command Modes
Syntax
Syntax
Description
Defaults
Instructions
Example
12 Confidential and Proprietary Information of ZTE CORPORATION
<key>
There is no key by default.
� When the key is not configured with the key command, the
authentication will not be performed on the interface.
� This command needs to work with the ip rip authentication
mode text command.
This example describes how to configure the key zxr10 on the
fei_1/1 interface.
ZXR10(config)#interface fei_1/1
ZXR10(config-if)#ip rip authentication key zxr10
ip rip authentication mode
ip rip authentication
key-chain
Use this command to configure to provide the key-chain for the
MD5 authentication of an interface. Delete a key node with the no
form of this command.
Interface configuration
ip rip authentication key-chain <key-id><key-string>
no ip rip authentication key-chain <key-id>
<key-id>
<key-string>
There is no key-chain by default.
This command needs to work with the ip rip authentication
mode md5 command.
This example describes how to configure the key-chain 1 as abcd
on the fei_1/1 interface and delete it.
ZXR10(config)#interface fei_1/1
ZXR10(config-if)#ip rip authentication key_chain 1 abcd
ZXR10(config-if)#no ip rip authentication key_chain 1
Valid key, 1~16 characters
Number of the key node in the key-chain,
1~255
Key value, 1~16 characters.