Ip Rip Authentication Mode; Ip Rip Interface - Zte ZXR10 Command Manual

Related
Commands
Purpose
Command Modes
Syntax
Syntax
Description
Defaults
Instructions
Example
Related
Commands
Purpose
Command Modes
Syntax
Syntax
Description
Defaults
Instructions

ip rip authentication mode

ip rip authentication mode

Use this command to specify the authentication type for the RIP
version 2 message packets. Clear the authentication with the no
form of this command.
Interface configuration
ip rip authentication mode {text | md5}
no ip rip authentication mode
text
md5
There is no authentication mode by default.
The RIP version 1 does not support the authentication.
This example describes how to configure the MD5 authentication
on the fei_1/1 interface.
ZXR10(config)#interface fei_1/1
ZXR10(config-if)#ip rip authentication mode md5
ip rip authentication key
ip rip authentication key_chain

ip rip interface

Use this command to configure the method to send/receive route
information on an interface. Restore default with the no form of
this command.
Interface configuration
ip rip interface {passive | active}
no ip rip interface
passive
active
The RIP route information is sent and received at the same time.
� This command can be used to reduce the bandwidth occupation
of the network.
Confidential and Proprietary Information of ZTE CORPORATION
Simple text authentication
MD5 authentication
Enables an interface only to receive but not
to send RIP route update information.
Enables an interface only to send but not to
receive RIP route update information.
Chapter 2 RIP Protocol
13