Offset-List; Output-Delay - Zte ZXR10 Command Manual

ZXR10 Command Manual (IPv4 Routing Volume I)
Example
Related
Commands
Purpose
Command Modes
Syntax
Syntax
Description
Defaults
Instructions
Example
Purpose
Command Modes
Syntax
20 Confidential and Proprietary Information of ZTE CORPORATION
� The RIP sends the update information to the specified network
interface. If some network of interface is not specified, there
will be no advertisement of RIP update.
This example describes how to specify the network for the RIP
routing.
ZXR10(config)#router rip
ZXR10(config-router)#network 202.102.3.0 0.0.0.255
router rip

offset-list

Use this command to configure the particular metric offset of route
received/sent . Delete the metric special offset for sending/receiv-
ing routes with the no form of this command. There will be no
offset in metric when route is received or sent with the no form of
this command.
Router configuration and address family configuration
offset-list <access-list-number>{in | out}<offset>[interface
<interface-name>]
no offset-list <access-list-number>{in | out}[interface <inter
face-name>]
<access-list-number>
in | out
<offset>
<interface-name>
This command is disabled by default.
If an interface name is specified, the offset value is effective only
for the specified interface.
This example adds the offset 2 to the metric value of the received
route corresponding to the access list 3.
ZXR10(config)#router rip
ZXR10(config-router)#offset-list 3 in 2

output-delay

Use this command to change the delay among the group of pack-
ets RIP update sends. Restore default with the no form of this
command.
Router configuration
output-delay <packets><delay>
Access list entry, 1~99
Receiving or sending route
Offset metric value, 0~16
Interface name