Table of Contents
Advertisement
5.14.5 Central Management Service
This service only supports Central Management System (NCS). When
starting the Central Management Service option of the system, the Main
Console would send event information to NCS and allow NCS system to
control I/O device from remote side.
*CMS is only supported in IP CamSecure Pro/Pro Plus/Pro Mega.
Note:
1. To enable this action, go Guard >Action and select "Send to Central
Server" to enable the action triggered by preference event.
2.
Please refer the user manual of Central Management System for detail
information.
Client list:
Client Count:
system.
Kill Client:
Highlight an IP address and click on the "Kill Client" button
to block the client from your client list.
Kill All Clients:
logging to your system.
Service:
Server Status:
Options:
Adjust the setting only when the server is stopped.
Show the amount of NCS Servers that are connecting to
Click on this button and then block all the clients
Click on Start/Stop to turn on/off this option.
IP CamSecure
5. Configuration
Client
Service
Options
Advertisement
Table of Contents
