5.4 Setting - PTZ Config
Basic Setting
Advanced Setting
Miscellaneous
Install PTZ cameras and follow the instruction of the camera
manufacturers. A PTZ camera is usually connected to the PC with
RS-485/RS-422.
Check the box on the camera list to activate the PTZ control function of a
PTZ camera.
Select the camera model, com port, baud rate, and
Basic Setting:
address according to your PTZ camera.
Note:
If the camera model is IP camera, you can work PTZ function
directly without the com port, baud rate, and address settings.
Advanced Setting:
and auto pan speed. Adjust the settings by dragging the bars.
Miscellaneous:
Patrol Group:
the detail.
You may setup the pan speed, tilt speed, zoom speed
You can setup the Patrol Group, please see page 35 for
IP CamSecure
5. Configuration