Table of Contents
Advertisement
IP CamSecure
1. MainConsole
1.3.1 Preset/ Go
Adjust the camera view until you are satisfied. Click on the Set icon and
set up the view as the preset point 01. Adjust the camera view again and
set up the preset point 02. Repeat the process until finish setting up all
preset points. You can enter any names you want instead of the preset
point 01, preset point 02, preset point 03..., click on the Go icon and view
the result of your setting.
Note:
For the speed settings of PTZ camera, go to Config > Setting>PTZ
Config to setup the advanced settings.
1.3.2 Zoom
Click on the + and – signs to zoom in and zoom out the view.
1.3.3 Focus
You can select to have the camera focused near or far. To focus near
means objects that are closer will be clearer than the objects that are
further away. On contrast, to focus far means objects that are further will
be clearer than the objects that are closer. Click on the Focus icon and
select auto focus if you want the system to decide the focus point for you.
1.3.4 Patrol
Go to Patrol > Set Patrol to obtain
the Patrol Setup dialog. From the left
window, select the cameras that
you would like to have in the patrol
group. Align the cameras in order in
the right window and adjust the
time. Rename the group name if
you want. After completing the
setup, check the Active option, and
then click OK.
You can setup up to four groups of auto patrol. To start or stop, click on
the Patrol icon in the Main Console, and select Start Patrol or Stop Patrol.
Advertisement
Table of Contents
