Table of Contents
Advertisement
IP CamSecure
9. Remote Live Viewer
9.3 PTZ Control
Control the movement of PTZ cameras. With cameras that support PTZ
control, you can move, zoom, patrol, adjust the focus, and set preset
points of the cameras.
9.3.1 Preset/ Go
Adjust the camera view until satisfied. Click on the Set icon and set up the
view as the preset point 01. Adjust the camera view again and set up the
preset point 02. Repeat the process until finish setting up all preset points.
Enter any names you want instead of the preset point 01, preset point 02,
preset point 03..., click on the Go icon and view the result of your setting.
Note:
For the speed settings of PTZ camera, please setup on Main Console
> Config > Setting>PTZ Config.
9.3.2 Zoom
Click on the + and – signs to zoom in and zoom out the view.
9.3.3 Focus
You can select to have the camera focused near or far. To focus near
means objects that are closer will be clearer than the objects that are
further away. On contrast, to focus far means objects that are further will
be clearer than the objects that are closer. Click on the Focus icon and
select auto focus if you want the system to decide the focus point for you.
9.3.4 Patrol
To control PTZ camera to patrol around pre-defined path of preset points,
please click on Patrol button to start/stop patrol.
Note:
To setup patrol path, please setup on Main Console > Config >
Setting>PTZ Config > Patrol.
Advertisement
Table of Contents
