Beurer PM 70 Operating Instructions Manual page 32

Things to know about the recordings
As soon as you have started the recording, your HR monitor
starts recording your training data. Your HR monitor continually
records your training data until you save or delete this. This also
applies when you first start training on the following day. The run-
ning time also allows you to stop your training session at any
time.
If "0" is displayed for a longer period on the display, this means
that the receipt of the signals has been interrupted. In this case
change into the menu, by pressing MENU 7 times.
Training
The HR monitor tries to make contact with the devices once more.
Your HR watch has a memory. You can record up to 24 hours of
your training session. A maximum of 50 laps is possible for each
training. Your HR watch informs you if the memory is almost full.
At this point, at the latest, we recommend transmitting the re-
cordings to your PC and thus emptying the memory on the HR
watch. Alternatively you can delete all recordings manually. Read
the section "Delete all recordings" in this chapter to find out how
to delete the recordings.
You can let your training data be displayed. In the menu,
Result
the last recording stopped can be called. In the menu
Lap Result
you can see the laps for this recording.
As soon as you have transferred the recordings into the EasyFit
software, you can view and analyze them there. The memory will
be deleted every time you have successfully transferred the data
to the PC. You can find explanations regarding the transfer of
data to the PC in the chapter "EasyFit Software".
30