A
134
135
C
D
136
137
Workshop Manual KD 441_cod. 1.5302.865_2
Valve/rocker arm clearance
Adjust the valve/rocker arm clearance when the engine is cold.
Turn the engine clockwise and place the piston at the TDC.
B
Loosen lock nut A while locking lock nut B in its position, as shown in
the figure.
Set clearance at 0.10÷0.15 mm using a thickness gauge.
A
Injector
Assemble injector C together with copper seal D.
Tighten injector bracket B fastening screw A to the cylinder head to a
torque of 9 Nm.
A
The correct protrusion of the spray nozzle from the cylinder
B
head surface is obtained with copper seal D available in the
following thicknesses: 0.5, 1 and 1.5 mm.
Rocker arm cover
A
Replace the seal and assemble the rocker arm cover by tightening
the 3 screws A to a torque of 10 Nm.
nd
ed_ rev. 01.
Caution – Warning
Tighten lock nut A at a torque of 7 Nm.
Important
Caution – Warning
6
Reassembly
- 57 -