Table of Contents
Advertisement
8
Fuel system
F
154
155
156
- 64 -
G
Solenoid valve
Dimensions (mm)
F
G
10
10
Characteristics:
12 V 0.9 A.
Injection pump
This is of the simplified QLC type; it is housed in the crankcase and is
controlled by the camshaft via tappets.
Injection pump fitting in the crankcase
Fit pad 2 into the tappet so that recess B points downwards as shown
in the figure. (For pad spacer, see fig. 165)
Fit the injection pump into the crankcase complete with gasket po-
sitioning flow control 1 in the fork of lever 5 which should be in the
maximum flow position.
Caution – Warning
When removing the injection pump from its housing make sure
that spacer 2 is not dropped into the oil sump; injection pump
operation will be hampered if the spacer is not installed.
Workshop Manual KD 441_cod. 1.5302.865_2
nd
ed_ rev. 01.
Advertisement
Table of Contents
