36
37
D
E
38
39
Workshop Manual KD 441_cod. 1.5302.865_2
To remove the starter rim, it is advisable to cut it into several parts
with a hacksaw and to then use a chisel. To replace, slowly heat for
15-20 minutes to a temperature of 300°C max.
Fit the rim into the flywheel housing. make sure that it rests evenly
against the support of the housing itself.
Allow it to slowly cool.
Timing cover
Disassemble the oil filter cartridge.
Loosen the fastening screws of the timing cover including screw A
housed in the seat of the oil filter cartridge.
A
Components:
B Crankshaft
C Camshaft
D Equalizer shaft
E Speed governor / oil pump gear.
B
C
Camshaft
C
Remove camshaft C.
nd
ed_ rev. 01.
4
Disassembly
- 27 -