Connecting Rod - Kohler RD 441 Service Manual

20
21
22
23
Workshop Manual KD 441_cod. 1.5302.865_2
Caution – Warning
Do not demount when hot or the part could be deformed.
Loosen the four nuts and remove the cylinder head.
If the cylinder head surface is distorted, level it by removing up to 0.2
mm thickness.
Always replace the seal, see fig. 130-131 on page 55 for the correct
thickness.
For overhaul and cylinder head checks, see page 33

Connecting rod

Loosen the 4 fastening screws A of the bottom cap.
A
Tighten the hammer puller in the central hole and remove the bottom
cap.
Remove the bottom cap.
Caution – Warning
When reassembling the cap, replace sealing O-ring B and make
sure that hole C is facing towards the timing system housing
side.
C
B
nd
ed_ rev. 01.
4
Disassembly
- 23 -