Mounting The Injection Pump On The Engine; Injector And Injector Tube - Kohler KD 500 Workshop Manual

13
Engine assembly
76
77
78
- 38 -

Mounting the injection pump on the engine

Lower the tappet in the innermost point of the engine by slightly
turning the flywheel.
- Insert a seal of adequate thickness (see section "Injection lead"
point 5, page 37).
- Turn the motor stop lever to the STOP position.
- Set the adjuster sleeve of the injection pump about one
millimeter from the stop position on the adjuster block (fig. 77).
- Fit the injection pump into the engine block and, keeping it
pressed down, fix it in place by tightening the nut that holds
the relative bracket. (Match the marks made during the
demounting phase, see section "Removing the injection pump"
page 17)
Warning: consult section "Braked engine test" page 39, if
the position of the injection pump in relation to the casing
was not marked during the demounting operations or if a
new one must be installed.

Injector and injector tube

Mount the injector on the head, inserting the copper retention
seals (see section "Head" page 36).
Connect the injector to the pump with the injection pipe.
Warning: always use two wrenches to slacken off or
tighten injection pipes (fig. 78)
Workshop Manual KD500 _ cod. ED0053029390 - 1° ed_rev. 00