4
Disassembly
24
D
25
26
27
- 24 -
C
F
Place the piston to the B.D.C..
Loosen the screws of the cap on the connecting rod big end.
Rotate the crankshaft to T.D.C. position, until flywheel reference D is
aligned with C on the crankcase.
In T.D.C. position, the cylinder and the piston will be lifted as shown in
the figure.
Insert the two nylon bars F under the cylinder to prevent the piston from
being lowered.
Rotate the crankshaft to B.D.C. position to disconnect the cap on the
connecting rod big end from the centering pins of the connecting rod.
Workshop Manual KD 441_cod. 1.5302.865_2
nd
ed_ rev. 01.