Disabling Timer Mode; Priming The Machine After Fluid Out - Martin Magnum 1200 User Manual

D i s a b l i n g t i m e r m o d e
If you wish to simplify the remote control, you can disable the timer function.
This means that a short press on the FOG button will just produce a short burst
of fog and the timer will not be enabled.
1. Press the TIMER SET button once. The ON light flashes.
2. Turn the knob fully left to the "OFF" section.
3. Press the TIMER SET button again.
The zero times will be stored, disabling the timer. This will be remembered even
after the unit has been switched off. The ON and OFF lights remain off when the
timer is disabled.
To re-enable the timer function, store some non-zero times as described above.
P r i m i n g t h e m a c h i n e a f t e r f l u i d o u t
If the machine runs out of fluid it may not pump properly after refilling the fluid
due to airlocks in the fluid pipework.
To prime the machine, hold down the FOG button and turn the knob to
maximum. Keep the button held until the fog output is strong and steady. Then
turn the knob back to the required output level and release the FOG button.
If the machine is left to run when out of fluid, damage will be caused to the pump
which may cause premature pump failure.
14 Control settings