Setting The Timer; Setting The Dmx Start Address; Setting The Master-Slave Link Mode - Martin JEM Compact Hazer Pro User Manual

Use the Up/Down buttons to select the fan speed from  – .
Press the Enter button to store the fan setting.
The fan will run continuously if set above 0% and the RUN menu is set to FAN,
TIME or CONT.
If haze is being produced and the fan is off or set to a low speed, the fan speed
will be automatically increased to prevent build-up of haze at the machine output.
S e t t i n g t h e T i m e r
The timer can be operated in two different modes.
Mode 1
Cycle mode
Select the Time option from the Run menu.
The TRUN and TOFF values are set in seconds and are in the range 1-90 and
20-89 respectively. The haze and fan values are taken from the menu settings
for Haze and Fan. The timer will cycle continuously until the run menu is
changed.
Use this mode for maintaining a low level of haze in smaller venues.
Mode 2
ODTC (Optical Density Timer Control system) mode
Select the Time option from the Run menu.
The TRUN value is set in minutes and is in the range 1-90. The TOFF value
should be scrolled to max, at which point the display will show ODTC.
During the initial TRUN period the haze and fan values are both set to maximum.
When the TRUN period expires the haze and fan values are taken from the
menu settings for Haze and Fan. The timer will cycle once only, and will end by
displaying ODTC as the TOFF value.
Use this mode for rapidly filling a large venue, then dropping back to a level
suited to maintaining the haze density in the venue.
When the timer is running and the display is not showing a
menu, the display shows TRUN or TOFF as the timer cycles
between run and off modes.
S e t t i n g t h e D M X s t a r t a d d r e s s
Use the Previous / Next buttons to select the  option.
Use the Up/Down buttons to set the DMX start address from  to . If
you hold down the button the address will count up or down.
Press the Enter button to store the address setting.
The machine will automatically respond to a DMX controller whenever it is
connected.
When using in a DMX system ensure the LINK menu is set to RECV to avoid
causing DMX errors to other devices on the system.
S e t t i n g t h e m a s t e r - s l a v e l i n k m o d e
It is possible to control several machines from one. The primary machine, which
from commands are, is the Master. The other machines are Slaves. The
machines are interconnected with DMX cabling.
Control settings 13