1. Manuals
  2. Brands
  3. Martin Manuals
  4. Fog Machine
  5. Magnum 800
  6. User manual

Martin Magnum 800 User Manual

Hide thumbs
Table of Contents

Advertisement

Quick Links

Download this manual
USER GUIDE
Version 1.0

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Magnum 800 and is the answer not in the manual?

Questions and answers

Related Manuals for Martin Magnum 800

Summary of Contents for Martin Magnum 800

  • Page 1 USER GUIDE Version 1.0...

  • Page 2: Table Of Contents

    For optimum performance and safety, please read this manual thoroughly. Note: © 2003 Martin Professional A/S, Denmark. All rights reserved. No part of this manual may be reproduced, in any form or by any means, without permission in writing from Martin Professional A/S, Denmark.

  • Page 3: Introduction

    • Do not use the machine if it is in poor or unsafe condition, e.g., if the supply cord is damaged. • Always use genuine JEM / MARTIN fluid in the machine, other fluids may be dangerous. • Refer all service to qualified service personnel.

  • Page 4: Installing The Fluid Bottle

    Always disconnect the machine from the power supply when working with the fluid system. 1. Fit the bottle of JEM / MARTIN fluid into the fluid compartment and fit the cap with fluid pipe. 2. Do not attempt to fill the bottle whilst in the machine.

  • Page 5: Operating The Remote

    • Do not use solvents to clean the casework of the machine as this may remove the silk screen printing. • Only use JEM / MARTIN fluid in the machine. Other fluids may cause damage to the heat exchanger and other components.

  • Page 6: Troubleshooting Guide

    TROUBLESHOOTING GUIDE All checks marked * must be carried out with the power supply disconnected from the machine. The inside of the machine contains parts at high temperature, always allow the machine to cool before removing the cover. Symptom Probable Cause Remedy •...

  • Page 7: Technical Specification

    TECHNICAL SPECIFICATION Heat Exchanger • Input power UK/Europe 750W @ 240V, 50Hz USA 750W @ 120V, 60Hz • Construction Copper vaporising coil in cast aluminium with integral heater • Operating temperature 300° C maximum • Over-temperature protection Direct contact thermal cut-out with manual reset Fuse •...
  • Page 8 Martin Professional A/S,Olof Palmes Allé 18, DK-8200,Aarhus N Phone: +45 87 40 00 00 Internet: www.martin.dk...

Table of Contents