Quick Start; Setting Up; Making Fog - Martin Magnum 1200 User Manual

Quick Start

You are no doubt eager to switch on the machine and try it out by making a lot
of fog. This section tells you how to do that. However, please also make the time
to read the safety and servicing instructions in the remainder of this manual.
S e t t i n g u p
Locate the machine in a suitably large area with nothing in front of the smoke
output.
Fill the fluid tank with MARTIN-approved fluid (see page 18). The fluid
compartment is opened by pulling outwards on the cover (pull using a finger in
the round hole).
Connect a suitably rated power supply to the machine. The power requirements
are:
Magnum 1200: 3.9A at 230V (EU) or 7.4A at 120V (US)
Magnum 1800: 5.2A at 230V (EU) or 8.6A at 120V (US)
Connect the remote control to the REMOTE IN connector on the rear panel.
Turn on the power switch. The red Heat indicator on the remote and the top of
the unit will light. After about 7-10 minutes the green Ready indicator on the
remote and the top of the unit will light. The machine is then ready to produce
fog. To obtain maximum fog output wait another couple of minutes for the Heat
indicator to go out.
M a k i n g f o g
Once the machine has heated up, hold the FOG button on the remote to start
the fog output. (Pressing the FOG button for less than 1 second will start Timer
mode if times are programmed).
You can set the fog density by turning the knob. If the knob is turned fully
anticlockwise, no fog will be produced.
8 Quick Start