Troubleshooting; Error Messages - Microlife WatchBP office Instruction Manual

Troubleshooting

Problem Possible cause
No power(No LCD display) Power supply is not
properly plugged in
Battery is fully discharged Recharge the rechargeable battery by plugging in
Cuff does not inflate Loose connection of the
properly tube
Leakage of the tube or
bladder
No result displayed The Hide function is
between measurements activated
33
How to make correction
Plug power supply into wall socket.
the power supply.
Make sure the tube of the cuff is securely
connected to the device.
Check for cracks on the tube or the bladder. Please
contact Microlife customer service for this issue.
Disable "hide" function, or use «ROUTINE» mode to
measure the blood pressure.

Error messages

If an error occurs during measurement, the
measurement is interrupted and an error
message «Err» is displayed.
ROURINE
•
Please contact your local
Microlife service center if the
error persists.
•
If you think the results
are unusual, please read
through the information
in this instruction manual
carefully.
Error Description Potential cause and
remedy
«Err 1» Signal too The pulse signals
weak on the cuff are too
weak. Re-position the
cuff and repeat the
measurement.
«Err 2» Error signal During the
measurement,
error signals were
detected by the cuff,
caused for instance by
movement or muscle
tension. Repeat the
measurement, keeping
your arm still.
34
EN