Table of Contents
Advertisement
Flash Interfaces
C
F
OMPACT
LASH
Connector J9 provides a socket for a Type I or Type II CompactFlash (CF) module. The CF
interface supports operation in DMA mode. Contact
have been tested and qualified as bootable devices.
After installing the OS on the CF, you may configure the module to be the first boot device,
which will reduce boot time.
The blue LED at location D11 (upper right corner of the board as shown in Figure 7) lights with
disk activity on the CF port.
USB S
E
OCKET
The Iguana includes an eUSB port. The VersaLogic VL-F15 Series of eUSB SSD modules are
available in sizes of 2 GB or 4 GB. Contact
secured to the on-board standoff using M2.5 x 6mm pan head Philips nylon screws. These screws
are available in quantities of 10 in the VL-HDW-108 hardware kit from VersaLogic.
The blue LED at location D6 (upper right corner of the board as shown in Figure 7) lights with
activity on the eUSB port, if supported by the eUSB module.
PCI
M
C
E
INI
ARD
The socket at location J13 accepts a full-height PCI Express Mini Card or an mSATA module.
The PCIe Mini Card interface includes one PCIe x1 lane, one USB 2.0 channel, and the SMBus
interface. The socket is compatible with plug-in Wi-Fi modems, GPS receivers, flash data
storage, and other cards for added flexibility. An Intel WiFi Link 5300 PCI Express Mini Card
(VL-WD10-CBN) is available from VersaLogic. A WiFi antenna (VL-CBR-ANT01) and a 12"
WiFi card to bulkhead RP-SMA transition cable (VL-CBR-0201) are also available. For more
information, contact Sales@VersaLogic.com.
VL-EPIC-25 Reference Manual
Table 11: eUSB Port Locations
J18
Signal
Pin
Name
1
+5V
2
NC
3
D-
4
NC
5
D+
6
NC
7
GND
8
NC
9
Key
10
LED
/
SATA S
M
OCKET
VersaLogic Sales
VersaLogic Sales
to order. eUSB modules are
Function
+5V Power Supply
Not connected
Data –
Not connected
Data +
Not connected
Ground
Not connected
Physical key
SSD LED
Interfaces and Connectors
to order CF modules that
33
Advertisement
Table of Contents
