Proxim AP-4000 User Manual page 66

Advanced Configuration
Interfaces
DCS can be configured using the following interfaces:
•
Web (HTTP) Interface
•
Command Line Interface (CLI)
•
MIB (SNMP) Requirements
Web (HTTP) Interface
The HTTP Interface (Web browser Interface) provides easy access to configuration settings and network statistics from
any computer on the network. You can access the HTTP Interface over your LAN (switch, hub, etc.), over the Internet, or
with a "crossover" Ethernet cable connected directly to your computer's Ethernet Port.
The user will be able to enable/disable the Dynamic Channel Selection feature in the Wireless subtab. If DCS is disabled,
all DCS configuration options are grayed out showing the text fields are not configurable.
The default value for DCS text field is Disable and for DCS Threshold is 5.
To configure the HTTP (Web) interface, click Configure>Interfaces>Wireless A and B.
To reset your configuration, click Cancel.
You can configure HTTP page for configuring the DCS feature for each interface separately.
Figure 4-16 Configurable DCS fields
NOTE: Changes to these parameters except Wireless Service Status, DCS and DCS Threshold require Access Point
reboot in order to take effect.
AP-4000/4000M/4900M User Guide
66