Proxim AP-4000 User Manual page 218

Command Line Interface (CLI)
Configuring the AP using CLI commands
MAC Address Format
Response Time
Maximum Retransmission
Authorization Lifetime
Accounting Update Interval
Accounting Inactivity Timer
Index
Primary/Backup
Profile Name
Server Status
Server Addressing Format
IP Address/Host Name
Destination Port
VLAN Identifier
MAC Address Format
Response Time
Maximum Retransmission
.
.
.
Index
Primary/Backup
Profile Name
Server Status
Server Addressing Format
IP Address/Host Name
Destination Port
VLAN Identifier
MAC Address Format
Response Time
Maximum Retransmission
Authorization Lifetime
Accounting Update Interval
Accounting Inactivity Timer
Figure A-16 Result of "showradiustbl" CLI Command
Set Rogue Scan Parameters
Perform the following command to enable or disable Rogue Scan on a wireless interface and configure the scanning
parameters.
The cycletime parameter is only configured for background scanning mode.
[Device-Name]>set rscantbl <3 or 4> mode <1 for background scanning, 2 for continuous
scanning> cycletime <cycletime from 1–1440 minutes> status <enable/disable>
NOTE: Rogue Scan cannot be enabled on a wireless interface when the Wireless Service Status on that interface is
shutdown. First, resume service on the wireless interface.
: dashdelimited
: 3
: 3
: 0
: 0
: 5
: 1
: Backup
: MAC Authentication
: notReady
: ipaddr
: 0.0.0.0
: 1812
: -1
: dashdelimited
: 3
: 3
: 4
: Backup
: Management Access
: notReady
: ipaddr
: 0.0.0.0
: 1812
: -1
: dashdelimited
: 3
: 3
: 0
: 0
: 5
AP-4000/4000M/4900M User Guide
217