Proxim AP-4000 User Manual page 28

Installation and Initialization
Hardware Installation
Wall Mounting
Follow these steps to mount the unit on a wall:
1. If the unit's power supply is plugged in, unplug it.
2. Put the mounting plate up to the wall so that the embossed letter "L" is on top (see figure). If the plate is correctly
oriented, the circular tab that is vertically aligned with the square hole should be on top.
3. Fasten the mounting plate with two screws through the circular holes of the plate. Depending on the type of wall, you
may need to use the two fasteners provided.
4. Holding the unit so that the connectors on the rear are facing left, align the two holes on the bottom of the unit with the
two tabs on the mounting plate. Press the unit down so it is flush with the plate.
5. Carefully slide the unit to the right until the tabs snap securely onto the narrow holes of the unit. If the unit is mounted
correctly, no portion of the mounting plate should protrude from any of the sides of the unit.
Figure 2-7 Mounting the AP to a Wall
Ceiling Mounting
Follow these steps to mount the unit to a ceiling:
1. If the unit's power supply is plugged in, unplug it.
2. Snap the rectangular tabs on the back of the mounting plate onto a ceiling T-bar. You may need to slightly rotate the
plate until it securely snaps onto the T-bar.
3. Fasten the mounting plate to the ceiling tile with two screws through the circular holes of the plate.
4. Position so that the embossed letter "L" on the mounting plate is facing up (see previous figure). Holding the unit so
that the connectors on the rear are facing to left, align the two holes on the bottom of the unit with the two tabs on the
mounting plate. Press the unit up so it is flush with the plate.
5. Carefully slide the unit to the right until the tabs snap securely onto the narrow holes of the unit. If the unit is mounted
correctly, no portion of the mounting plate should protrude from any of the sides of the unit.
Vehicle Mounting (AP-4900M only)
Follow these steps to mount the AP-4900M in a vehicle:
1. Attach the mounting plate up to the wall or to the wall partition (cage) behind the passenger seat in a vehicle. The
knobs that fit into the keyholes on the AP-4900M should be in a vertical line.
AP-4000/4000M/4900M User Guide
28